3.5 Preparing for use
Check that the mesh base can move freely.
Only adjust the mesh base while it is in a
horizontal position, securely fixed to the
supporting legs, or to the supports provided
within the bed surround.
Check that the mattress is attached to the
mesh base properly. Insert the plug into the
wall socket.
3.6 Tips for use
A new mattress has a certain amount of
rigidity, which will disappear within a few days.
Consequently, your mattress will not optimally
follow the contours of the mesh base when it
is initially adjusted. We therefore recom mend
that you lie down on the mattress while
adjusting the positions for the first time.
4. Use
4.1 Manually adjustable sections
Foot end
The foot end has six adjustable positions.
Carefully pull on the handle until the desired
position is reached. To put the foot end into a
lower position you must first pull it up as far as
it will go and then lower it again.
4.2 Electrically adjustable sections
The handset is used to
adjust the elec
trically
adjustable sections (see
fig. 5).
1. Raise back section
2. Lower back section
3. Raise foot end*
4. Lower foot end*
5. Raise head support,
back section and foot
end *
6. Lower head support,
back section and foot
end*
Press one of the 'up' or 'down' buttons, holding
it down until the desired position is reached.
Only one button can be operated at a time.
The electrical parts of an AVS mesh base
operate on 24V low-voltage current.
* type 466
For technical reasons AVS mesh bases wider than 120 cm
cannot be equipped with Comfortslides
®
.
GB16
Type 455
Type 466
fig. 5
_02QZ1_3815 AVS455_466 bw.pdf - pag.16
October 6, 2008
LET OP !!! Lage resolutie!