16. Setting of the operating time (output speed)
16.1 Setting of the operating time via internal command signal
.
Loosen 4 screws (8.1) and remove cover (figure U).
.
Set required operating time at potentiometer ”OPERATING TIME”
(figure V).
Short operating time: turn counter-clockwise.
Long operating time: turn clockwise.
Speed ranges see technical data sheet
.
Replace cover and fasten 4 bolts (8.1) evenly crosswise.
23
Multi-turn actuators SARV 07.1 - SARV 10.1
Operation instructions
AUMA VARIOMATIC
Switch
compartment cover
AUMA VARIOMATIC
Local controls
Figure U: Actuator SAR with controls AUMA VARIOMATIC
DIP switch S1
for programming
Cover plate
standard
ON
1
23
4
5
6
7
Potentiometer
for setting of
OPERATING TIME
Diagnosis LED (green):
Illuminated when
ready
Diagnosis LED (red):
Motor protection
tripped
Diagnosis LED (green):
Enable REMOTE (option)
always installed,
illuminated during normal
operation
Diagnosis LEDs for
active REMOTE
control commands:
run command STOP (red)
run command OPEN (green)
run command CLOSE (yellow)
Logic board
Figure V: VARIOMATIC standard
