4.
Transport and storage
.
Transport to place of installation in sturdy packing.
.
Do not attach ropes or hooks to the handwheel for the purpose of lifting by
hoist.
.
If part-turn actuator is mounted on valve, attach ropes or hooks for the
purpose of lifting by hoist to valve and not to part-turn actuator.
.
Store in well-ventilated, dry room.
.
Protect against floor dampness by storage on a shelf or on a wooden pal-
let.
.
Cover to protect against dust and dirt.
.
Apply suitable corrosion protection agent to bright surfaces.
If part-turn actuators are to be stored for a long time (more than 6 months),
the following points must be observed additionally:
.
Prior to storage: Protect bright surfaces, in particular the output drive parts
and mounting surface, with long-term corrosion protection agent.
.
Check for corrosion approximately every 6 months. If first signs of corro-
sion show, apply new corrosion protection.
After mounting, connect part-turn actuator immediately to electrical mains,
so that condensation is prevented by the heater.
5.
Packaging
Our products are protected by special packaging for the transport ex works.
The packaging consists of environmentally friendly materials which can
easily be separated and recycled.
For the disposal of the packaging material we recommend recycling and col-
lection centres.
We use the following packaging materials:
Wooden material boards (OSB)/cardboard/paper/PE film
6.
Fitting the ball handle/
manual operation
To avoid damage during transport, the ball handles are fitted to the inside of
the handwheel. Prior to commissioning, the ball handle has to be fitted in
the correct position.
6.1
Fitting the ball handle
.
Remove cap nut.
.
Pull out ball handle and re-insert in cor-
rect position.
.
Fasten with cap nut.
.
Remove sticker from the hand wheel
for fitting the ball handle.
6.2
Manual operation
Manual operation is activated by turning the handwheel. A change-over is
not required. The handwheel does not rotate during motor operation.
Turning the handwheel during motor operation results in
an extension or reduction of the operating time, depending
on the direction of rotation.
5
Part-turn actuators SG 03.3 – SG 04.3
Operation instructions
AUMA NORM
2
1
3
4
Figure A1
Ball handle
Cap nut
