4.
Assembly
4.1.
Mounting position
The product described in this document can be operated without restriction in any
mounting position.
Damage due to radial forces!
Risk of gear damage for applications requiring transmission of radial forces to the
input shaft.
→
In these cases, do NOT directly mount connection shaft to input shaft but fit a
coupling or a cardan shaft to the input shaft.
4.2.
Handwheel fitting
Gearboxes designed for manual operation are supplied with a separate handwheel.
Fitting is performed on site according to the description below.
Figure 8: Handwheel (example)
[1]
Retaining ring for input shaft (partly required)
[2]
Gear input shaft
[3]
Spacer (partly required)
[4]
Handwheel
[5]
Spacer (partly required)
[6]
Retaining ring
[7]
Ball handle
1.
For input shafts with keyway: Place retaining ring [1] onto input shaft [2].
2.
If required, fit spacer [3].
3.
Slip handwheel [4] onto input shaft.
4.
If required, fit spacer [5].
5.
Secure handwheel [4] using the retaining ring [6] supplied.
6.
Fit ball handle [7] to handwheel.
4.3.
Multi-turn actuators for motor operation
Refer to the operation instructions pertaining to the multi-turn actuator for indications
on how to mount multi-turn actuators to gearboxes.
13
GS 315 – GS 500
GZ 30.1 – GZ 40.1
Assembly
