Your PRO 9845 Keyless Entry System has many features and available options some
of which must be selected at time of installation. For your reference, the list on the back
page of this manual shows what features and options have been installed with this
particular system. Consult your installing dealer for options that may have been
installed and are not listed.
REMOTE DOOR LOCKING - ACTIVE
1. Turn the engine off, exit the vehicle, and close all doors.
2. Press and release the left button of your key chain transmitter one time, the doors will
lock, the parking lights will flash once, the vehicle's horn (or optional siren) will chirp
once, and the dash mounted LED will begin to flash slowly confirming the system is
locked.
SILENT LOCKING - ACTIVE
1. Turn the engine off, exit the vehicle, and close all doors.
2. Press and hold the left button of your key chain transmitter for two seconds, the doors
will lock, the parking lights will flash once, and the dash mounted LED will begin to flash
slowly confirming the system is locked. The horn or optional siren will not chirp.
BACKUP PASSIVE OPERATION (AUTOMATIC)
If the passive arming feature has been selected:
Turn the engine off, exit the vehicle, and close all doors.
The dash mounted LED will immediately begin to flash rapidly indicating that the 30 second
passive arming timer has begun.
If any entry point is opened during the 30 second arming cycle, arming will be suspended.
When all entry points are closed, the arming cycle will begin again.
At the end of the 30 seconds, the parking lights will flash once, the vehicle's horn (or optional
siren) will chirp once, and the dash mounted LED will begin to flash slowly confirming the
system is armed. If the horn (or optional siren) did not sound when arming, then the chirps
have been turned off. Please refer to the section titled "Eliminating the Arm/Disarm Chirps"
later in this manual. Passive door locking is a selectable feature. The doors may or may
not lock passively dependent upon the setup during installation.
PROTECTION WHILE THE SYSTEM IS ARMED
If the optional Starter Interrupt relay has been installed, then whenever the system is
armed, the vehicle starter circuit is disabled, even with the ignition key, the vehicle will not
start. Should an attempt be made to start the engine, while the PRO 9845 is armed, the
starter circuit will remain interrupted.
Whenever the system is armed, the dash mounted LED will slowly flash. This serves as a
visual deterrent to a potential thief. This LED is a very low current light emitting diode, and
will not cause the battery to drain even if left unattended for long periods of time.
Page 2
