128-8839
16 of 24
16
BLUE/RED WIRE:
Delayed 300 mA Pulsed Output / Channel 7
The light blue/red wire pulses to ground via an independent RF channel from the keychain transmitter. This is
a transistorized, low current output, and should only be used to drive an external relay coil.
WARNING!
Connecting the light blue/red to the high current circuits, will damage the control module.
Connect the light blue/red to terminal #86 of the AS - 9256 relay (or equivalent 30 A automotive relay) and wire
the remaining relay contacts to perform the selected function of channel 7.
3 PIN INPUT/OUTPUT HARNESS:
DARK BLUE/BLACK TRACE WIRE:
External Trigger Input
The Dark Blue/Black trace wire allows the remote start unit to be activated from an external source. The
intent of this wire is to allow the unit to be controlled from a "POSSE/CAR-LINK" paging system or similar
device. When this wire receives a ground pulse, the unit will start the vehicle. Connect this wire to a ground
pulsed output from the controlling circuit.
GREEN w/ WHITE TRACE WIRE:
Entry Illumination Ground Output
This wire provides a 30 second ground output (300 mA Max.) whenever the remote is used to unlock the
doors. This wire should be connected to an external relay, and wired to the vehicles interior entry lighting
whenever the optional Interior Illumination circuit is desired. See below for relay wiring details.
BLACK w/ WHITE TRACE WIRE:
300 mA Horn Output
The black w/ white trace wire is provided to beep the vehicle’s horn. This is a transistorized low current
output, and should only be connected to the low current ground output from the vehicle’s horn switch.
If the vehicle uses a +12 VDC horn switch, then connect the black w/ white trace wire to terminal #86 of the
AS 9256 relay ( or an equivalent 30 Amp automotive relay ), and connect relay terminal #85 to a fused +12
VDC battery source. Connect relay terminal #87 to the vehicle’s horn switch output, and connect relay
terminal #30 to a fused +12 VDC battery source.
Entry Illumination Detail
TIMED START PROGRAM:
The Remote Start unit has the ability to start the vehicle automatically at timed intervals. This feature is useful
in extremely cold climates where starting the engine is the only means to keep the battery charged and fluids
warm. The operator has the option to have the unit start every 2 or 4 hours for a maximum of 48 hours. Factory
preset is to start at 4 hour intervals. To select 2 or 4 hour automatic start timer:
1. Start by holding the Pushbutton Switch found on the windshield mount receiver on.
2. While holding the Pushbutton Switch, turn the Ignition Switch On then Off
3a. Within 10 seconds of turning the Ignition Switch off, release and then Push On and release the Push-
button Switch 2 times, holding it on the second time until the siren and or lights flash and chirp 2
times, indicating that the 2 Hour Start Interval has successfully been set. or
3b. Within 10 seconds of turning the Ignition Switch off (Step 2), release and then Push On and release
the Pushbutton Switch 4 times, holding it on the fourth time until the siren and or lights flash and chirp
4 times, indicating that the 4 Hour Start Interval has successfully been set.
Note:
Once selected, 2 or 4, this timer interval will remain in memory until it is manually changed. To
change, the above sequence will have to be followed.
Содержание PRESTIGE PLATINUM SS6900
Страница 23: ...128 8839 23 of 24 23...