Audiovox PRESTIGE PLATINUM SS6900, Руководство по установке, Страница: 15 / 24

128-8839
15 of 24
15
5 PIN ACCESSORY OUTPUT HARNESS
DARK BLUE WIRE:
Delayed 300 mA Pulsed Output/Channel 3
The dark blue wire pulses to ground via an independent RF channel from the keychain transmitter. This is a
transistorized, low current output, and should only be used to drive an external relay coil.
This output is activated by the same transmitter button that is used to activate the remote start function. Press
and hold the trunk/key button to activate this trunk release output, or press and release the trunk/key button
two times within 2 seconds to activate the remote starter.
WARNING! Connecting the dark blue wire to the high current switched output of the trunk release circuits and
some remote start trigger inputs will damage the control module.
Connect the dark blue wire to terminal #86 of the AS-9256 relay (or equivalent 30 A automotive relay), connect
terminal #85 to a fused +12 volt source and wire the remaining relay contacts to perform the selected function
desired.
Channel 3 Relay Wiring Detail
GREEN w/ BLACK TRACE WIRE: 300mA Latched Channel 4 Output
The Green w/ Black Trace wire supplies a 300 mA switched output whenever channel four of the receiver is
accessed. Pressing the pre-programmed transmitter button(s) will access channel four and will remain
active, for up to 20 seconds, as long as the transmitter button(s) is held. This is a low current output and
must be connected to a relay to supply power to the device you intend to control. Connect the Green w/
Black Trace wire to terminal #86 of a VF45F11 P&B relay or equivalent. Connect terminal #85 of the relay to
a fused +12 volt source. Connect the common, normally open, and normally closed contacts of the relay to
perform the selected function of the channel 4 output.
Note: This wire also can be used for defrost activation as dictated by the setting of feature # 1 of Bank 3.
Anytime the vehicle is running under control of the Remote Start and Channel 4 is activated, then
dependent on the selection of this feature, Green/Black will be activated as a pulse for 1 second, or
for 10 minutes. Note this wire will not operate when the vehicle is running under the power of the
ignition key, only while under the control of the remote start or if not used for defrost then an output
will occur as indicated above.
WARNING! Connecting the Dark Green w/Black trace wire to any high current switched output
(300 mA max.) will damage the control module.
LIGHT BLUE/GREN WIRE: Delayed 300 mA Pulsed Output / Channel 5
The light blue/green wire pulses to ground via an independent RF channel from the keychain transmitter.
This is a transistorized, low current output, and should only be used to drive an external relay coil.
WARNING! Connecting the light blue/green to the high current switched output of trunk release circuits,
some remote start trigger inputs, will damage the control module.
Connect the light blue/green to terminal #86 of the AS - 9256 relay (or equivalent 30 A automotive relay) and
wire the remaining relay contacts to perform the selected function of channel 5.
LIGHT BLUE/BLACK WIRE: Delayed 300 mA Pulsed Output / Channel 6
The light blue/green wire pulses to ground via an independent RF channel from the keychain transmitter.
This is a transistorized, low current output, and should only be used to drive an external relay coil.
WARNING! Connecting the light blue/black to the high current circuits will damage the control module.
Connect the light blue/black to terminal 86 of the AS - 9256 relay (or equivalent 30 A automotive relay) and
wire the remaining relay contacts to perform the selected function of channel 6.
From 2 Pin