-6-
cs
TIME/FREQUENCY SELECTOR (T/F)
This unit can be set so that either the clock time or radio fre-
quency/CD functions will normally appear on the display panel.
Pressing the Time/Frequency Selector button when the radio fre-
quency or CD indication is shown will change the display to show
the time. The time will then be the priority setting and the display
will automatically return to time display 5 seconds after any other
radio, CD, or audio function display.
If the unit is set to time display priority, pressing the Time/Frequency
Selector button will change the display to show the radio frequency/
CD/AUX indication and this will then become the priority setting to
which the display automatically returns 5 seconds after any other
function is activated.
ct
REMOTE SENSOR
The sensor for the infrared signal from the wireless remote control
is located behind this lens. For optimal operation of the remote
control, always aim it toward the sensor.
cu
THEFT-DETERRENT L.E.D.
Located on the chassis behind the front panel, a light-emitting
diode (L.E.D.) will flash when the panel is removed. The flashing
light serves as a visual warning to the would-be thief that the unit
has been disabled by removal of the front panel.
dl
RE-SET BUTTON
A Re-Set button is located on the front of the chassis (front panel
must be removed to access the button). The re-set circuitry is
provided to protect the microprocessor circuitry and should only
be activated under the following circumstances as it will erase the
time and pre-set memories.
1. Upon initial installation after all wiring is completed.
2. After the position of the frequency step switch on the bottom of
the chassis has been changed.
3. If there is a malfunction of any of the switches on the unit,
pressing the Re-Set button may clear the system and return
to normal operation.
dm
FRONT PANEL RELEASE BUTTON
Pressing this button will cause the front panel to drop down to the
lowered position so a disc may be loaded or ejected or so that the
panel may be detached. To detach the front panel, press the
button so that the panel is lowered and then grasp the middle of it
and pull it off of the chassis. To re-attach the panel, position it
straight onto the chassis and then press until the mechanism
locks it into place.
NOTES ON USE OF FRONT PANEL
1. Make sure the front panel is right-side-up when attaching it to
the chassis as it cannot be attached when up-side down.
2. Do not press very hard on the front panel when attaching it to
the chassis. No more than light to moderate pressure should
be needed.
3. When taking the front panel with you, please use the supplied
carrying case to protect the panel from dirt and damage. Make
sure there is no dust or dirt on the electrical terminals on the
back of the panel as this could cause intermittent operation or
other malfunctions.
