-7-
SETTING THE CLOCK
1. Turn the radio on so that the radio frequency or clock time is shown on the display panel.
2. Press and hold the Select button
3
approximately 4 seconds until the time display begins flashing.
3. While the time display is still flashing, press the Manual Up Tuning button
(+)
to adjust the hours or the Manual Down Tuning
button
(–)
to adjust the minutes to the correct time.
4. When the correct time is shown on the display panel, press the Select button
3
again to return to normal display.
ERROR CODES
If a problem should develop while operating the CD player, the following error codes may be displayed on the LCD panel.
E-01:
Indicates an error in the unit reading the data on the disc.
E-02:
Indicates an error in the laser focus on the disc. May be caused by high temperature conditions in which case play will
resume when the temperature returns to normal range.
E-03:
Indicates a data and focus error. May be caused by high temperature conditions in which case play will resume when the
temperature returns to normal.
E-04:
Indicates a mechanical error.
E-05:
Indicates a problem with the loading or eject mechanism.
In case of any of the above indications, eject the disc, make sure it is clean, undamaged, and had been loaded correctly (label
side up). Re-load the disc and check for proper operation or try another disc. You may also try pressing the Re-set button
cq
on
the front of the chassis (remove the front panel), but this will also erase the time setting and pre-set memories. If these
suggestions do not solve the problem, contact an approved warranty station for further assistance.
FREQUENCY STEP SWITCH
This unit is supplied pre-set at the factory for reception of North American radio stations (10 KHz. channel spacing on AM, 200 KHz.
spacing on FM). Use in other areas of the world may require different channel spacing. A switch on the bottom of the chassis
allows selection of 9 KHz. AM/50 KHz. FM channel spacing. Slide the switch to the appropriate position using a small screwdriver
blade. The Re-Set button
cq
on the front of the chassis must then be pressed to activate the change of channel spacing.
