Your APS-750 Remote Start Alarm System has many features and available options some of
which are selected at time of installation. For your reference, the list on the back page of this
manual show what features and options have been installed. Consult your installing dealer
for options that may have been installed and are not listed.
ARMING THE SYSTEM - ACTIVE:
1. Turn the engine off, exit the vehicle, and close all doors, hood and trunk.
2. Press and release the arm/disarm button of your key chain transmitter one time.
The parking lights will flash once, the siren will chirp once, and the dash mounted LED will
begin to flash slowly confirming the system is armed. If you have the optional door lock/
unlock circuit installed, the doors will lock.
Note:
If the siren chirped three times, then you have left a door, hood, or trunk ajar. Simply
closing that opening will provide full protection. If the siren did not sound when arming, then
the chirps have been turned off. Refer to the section on "Eliminating the Arm/Disarm Chirps"
shown later in this manual.
SILENT ARMING - ACTIVE:
1. Turn the engine off, exit the vehicle, and close all doors, hood and trunk.
2. Press and hold the arm/disarm button of your key chain transmitter for two seconds.
The parking lights will flash once, and the dash mounted LED will begin to flash slowly
confirming the system is armed. The siren will not chirp. If you have the optional door lock/
unlock circuit installed, the doors will lock.
Note:
If the siren chirps three times, then you have left a door, hood, or trunk ajar. Simply
closing that opening will provide full protection.
ARMING THE SYSTEM - PASSIVE (AUTOMATIC)
If the passive arming feature has been selected:
1. Turn the engine off, exit the vehicle, and close all doors, hood and trunk.
The dash mounted LED will begin to flash rapidly indicating that the 30 second passive arming
timer has begun. If the LED does not begin to flash rapidly, then you have left a door, hood,
or trunk ajar. Closing this entry point will allow the arming cycle will begin. If any entry point
is opened during the 30 second arming cycle, arming will be suspended. When all entry
points are closed, the arming cycle will begin again.
At the end of the 30 seconds, The parking lights will flash once, the siren will chirp once, and
the dash mounted LED will begin to flash slowly confirming the system is armed. If the siren
did not sound when arming, then the chirps have been turned off. Refer to the section on
"Eliminating the Arm/Disarm Chirps" shown later in this manual. Passive door locking is a
selectable feature. If you have the optional door lock/unlock circuit installed, the doors may
or may not lock passively dependent upon the setup during installation.
PROTECTION WHILE THE SYSTEM IS ARMED:
Opening any protected entry point, hood, trunk, or doors will cause the alarm to trigger
immediately. The siren will sound and the parking lights will flash for 30 seconds, then stop
and continue to monitor all protected entry points. If the thief left the door opened, the unit will
128-5027
2 of 24
Page 2
