Audiovox Jensen VM8022, Инструкция по установке и эксплуатации

Страница: 7 / 24

VM8022
3
IMPORTANT!
The pink parking wire MUST
be connected to the switched
side of the parking break
circuit (the part that becomes
grounded when the brake is
applied).
FRONT SP
Purple Purple/Black
Stripe
Gray Gray/Black
Stripe
White/Black
Stripe
White Green/Black
Stripe
Green
Left Speaker
(Front)
Right Speaker
(Front)
Left Speaker
(Rear)
Right Speaker
(Rear)
Black
Yellow
Blue
Red
REAR SP
Power Antenna
Connect to power antenna or amplifier.
If not used, tape bare end of wire.
Accessory/Ignition
Connect to existing radio wire
or radio fuse.
Ground
Connect to ground terminal
or clean, unpainted part of chassis.
Memory/Battery
Connect to battery or 12 volt power
source that is always live. The radio will
not work if this wire is not connected.
A/V Media
Adapter Cable
Fuse (15A)
(Blue)
(Yellow)
Parking
(Yellow)
WIRING
NOTE: The amplifier in this
radio is only designed for use with
four speakers. Never combine
(bridge) outputs for use with two
speakers. Never ground negative
speaker leads to chassis ground.
Failure to wire exactly as shown
may cause electrical damage to the
radio.
NOTE: Only connect speakers with
a nominal impedance of 4 ohms.
Speakers with a load
impedance less than 4 ohms
could damage the unit.