128-6602
10 of 16
This Remote Car Starter will learn the tach rate of most vehicles single ignition coils, multiple coil packs, and or single
injector.
To learn tach;
1. Start with the ignition switch in the "OFF" position and the programming switch in the "ON" position.
2. Turn the ignition key to the ON position.
3. Flip the program switch OFF - ON - OFF - ON - OFF then ON.
4. Immediately turn the ignition key OFF.
5. Flip the program switch OFF, then start the vehicle using the ignition key.
6. When the unit senses the tach signal, the parking lights will begin to flash.
7. Flip the program switch ON. The parking lights will turn on for 3 seconds then turn off indicating that the tach signal
is stored and the tach program mode has been ended.
Diagnostics:
Enter the diagnostics selectable and turn on as described in the programmable feature section.
NOTE:Diagnostic mode is a temporary mode. Once you have accessed the diagnostic mode, the unit will
pause for two seconds then begin to flash the last stored shut down code. This code will be displayed
three times in succession, then the unit will automatically exit the diagnostic on mode.
The parking lights will flash a number of times indicating the reason for the last remote start shutdown. The light
flash indications are as follows:
1 Flash
5,10, 15, or 20 Minute Run Timer Expired
2 Flashes
Low or No Tach Signal (RPM)
3 Flashes
Positive Or Negative Shutdown Wire Activated
4 Flashes
Control Switch Moved to Off Position
5 Flashes
RF shutdown, Remote signal received, or manual start trigger wire reactivated.
6 Flashes
High RPM Signal Received
7 Flashes
Tach Signal Has Not Properly Been Learned
TIMED START PROGRAM:
The Remote Start unit has the ability to start the vehicle automatically at timed intervals. This feature is useful in
extremely cold climates where starting the engine is the only means to keep the battery charged and fluids warm.
The operator has the option to have the unit start every 2 or 4 hours for a maximum of 48 hours. Factory preset is to
start at 4 hour intervals. To select 2 or 4 hour automatic start timer:
1. Start with the Enable switch (Red Handle) in the "On" Position.
2. Turn the ignition on then off.
3. Within 10 seconds of the key turning off, cycle the enable switch Off, On, Off, On ( 2 times) to select a 2 hour timed
start interval. After 10 seconds, the lights will flash 2 times confirming the 2 hour start mode selected, or, cycle the
enable switch Off, On, Off, On, Off, On, Off, On (4 times) to select a 4 hour timed start interval. The lights will flash 4
times indicating the 4 hour start mode selected.
NOTE: Once selected, 2 or 4, this timer interval will remain in memory until it is manually changed. To change, the
above sequence will have to be followed.
TIMED START OPERATION:
To begin the start timer, within 10 seconds of turning off the ignition switch, activate the RF command to start 2 times.
The lights will flash 4 times. Indicating timed interval mode has been initiated. The vehicle will automatically start
every 2 or 4 hours as programmed. To cancel the timed start mode start the vehicle either by RF or by the ignition key.
10
