APB-216 C-D
1)
XLR Input connector
Plug your microphone or line-level source into this XLR
balanced connector. You can connect any type of
condenser or dynamic microphone here or also output
from a mixing console.
(Pinout: 1-Ground, 2-Hot, 3-Cold).
2)
Phantom power switch with indicator
If you are about to use a condenser microphone, turn the
Phantom power switch ON to feed your microphone with
48V. If you use dynamic microphone or microphone with
his own power, you can switch this OFF.
3) Mic/Line Input switch
26dB PAD – input sensitivity selector. If you are using
microphone as an input, this lever should be set to “Mic”
position. If you are using Line input e.g. output from the
mixing console, please set this switch to “Line” position.
In the Line position the Phantom power is automatically
turned OFF.
4) Input Gain level knob
You can set the input signal gain depending on the
connected audio source to reach the optimal output
level. You can check the signal level on the Level
indicator (5)
.
5
8) Battery and Charge Level indicator
When APB is turned ON and is running on battery, the
Battery indicator lights blue. Then the Charge indicator
indicates the actual battery charge level in percent.
When APB is turned ON and plugged to the mains, the
battery is being charged and the Battery indicator is off.
In this case the Charge indicator indicates a charging
process.
9) Mic/Line Output Switch
Output PAD. Each output is switchable between Mic and
Line output level.
Nominal Mic level: -20dBu
/
Nominal Line level: +6dBu
6
8
9
5
4
2
1
7
3
10
11
1
2
5) Input Level indicator
Displays the input signal level. To achieve nominal output
level, set the Input gain (4) so that the LED “OK” will be at
least blinking.
6) Power supply connector
Plug the Power adaptor cable here. Please use only
power adaptor supplied with AudioPressBox.
7) Power switch
With the power switch, you can turn your
AudioPressBox® ON or OFF. When AudioPressBox® is
turned on, Power indicator lights green.
