7
Operating
Please, at first turn down your preamplifier. Then bring the main switch
at the rear in the "on" position. The switch is located above the mains
socket. Now the AMP III is in stand-by mode.
For switching your AMP III on and off, please use the power button at
the front panel from now on. The main switch does not need to be oper-
ated unless you are absent for a long time. It must only be operated while
the AMP III is in stand by mode.
As mentioned above, your Audionet AMP III is able to detect a wrong
polarizing of the mains. The indication is done by the front LED between
the touch of the "power" ball and the "click" of the loudspeaker relays.
If the polarizing is correct, the LED flashes
Ä
_____
Ä
_____
Ä
etc.
However, if you should observe a fast signal
Ä
_
Ä
_
Ä
_
Ä
_
Ä
_
Ä
etc., flip
the plug in your wall outlet after having switched off the AMP III.
When the AMP III is in stand-by mode its power can be controlled by any
Audionet preamplifier using the "Audionet link". This feature is de-
scribed in the preamplifier manuals, too.
You only need a simple optical "Toslink" cable. Connect one of the pre-
amplifier outputs "Audionet Link" with the "Link" input of your AMP III.
Now the AMP III power follows the preamplifier. Length of the "Tos-
link" cable is not critical - so you can place the AMP III next to the
speakers if you prefer!
Power
Mains phase indicator
Audionet Link