Audiomedia GDF879, Руководство пользователя

Страница: 23 / 29

Device Connections
Notes of connection

This unit is designed to be used in a
vehicle with a 12-volt battery and negative
grounding. Before installing this unit to a
recreational vehicle, a bus, or a truck, make
sure the battery voltage is appropriate for
this unit to be used, otherwise, install a
transformer by professional to convert the
output voltage to 12V.

To avoid short circuit in the electrical
system, ensure that the negative battery
cable is disconnected before installation.

To prevent short circuit in the wiring and
damaging to this unit, secure all wirings
with cable clamp or adhesive tape. Route
the wirings in a secured, out of heating
place without touching any moving parts
such as gear shift, handbrake, and seat
rails to prevent the wiring insulation being
melted / wore off.

Never pass the yellow power cord through
the installation hole into the engine
compartment and connect to the car
battery. Otherwise, a high possibility of
serious short circuit to the electrical system
may be occurred.

Replacing a new fuse with 1 5A rating
when the old one is broken, using no fuse or
fuse with improper rating may cause
damage to this unit or even fires. If a proper
fuse is installed and electrical problems still
occur, please contact with any professional
car shops for inquiry.

DO NOT connect other equipments with
the car battery to avoid battery overheating.

Please make sure all the wiring
connections & the cables of the Speakers
are wellinsulated. Otherwise, this unit
may be damaged by short circuit.

If there is no ACC available, please connect
ACC lead to the power supply with a switch.

If an external power amplifier is connected,
please don't connect P.CONT lead to the
power lead of the external power amplifier,
otherwise, electric spark or other damage
may be resulted.

Never ground the speaker output to
prevent
the damage to the built-in power amplifier.

The minimum rating of the speakers
connected to this unit is 40W with 4 to 8 Ω
impedance.
EN - 21