AudioControl Architect 560, Руководство пользователя

Страница: 15 / 32

ARCHITECT
Model 560
Model 735
Model 760
Installer’s Guide
™
Equalizing the System
Before proceeding on to setting up the Speaker Optimization
controls on the Architect, it’s a good idea to make sure that you
have everything connected and working properly.
1. Double-check all connections. Make certain that all of the
audio and speaker connections are firmly seated and tight-
ened down.
2. Turn on your audio system. The Power LED on the Architect
should be Blue, the Protection LED should be Blue (after a
few seconds of Red on startup) and (unless you have de-
feated the Signal-Sense) the Channel Status LEDs should
be off.
3. Start one of the audio sources playing and send that signal to
the Architect (how you do this depends on your particular
multi-room system). The zone status LED should illuminate
Blue within one second after the music begins.
4. Check each speaker output zone to ensure that each one
plays properly.
5. With all the speaker loads turned on, turn up the volume and
make certain that the channel status LEDs on the Architect
stay Blue. If they slowly toggle between Blue and Red, then
there is either a short in the speaker wiring, or the combined
speaker load is too low.
Congratulations! You’re ready to go on to setting the Speaker
Optimization controls.
The following are ex-
amples of typical settings of
the Architect™ 700 Series
Speaker Optimizer controls.
Naturally, the results of adjust-
ments will vary depending on
the individual acoustic envi-
ronment, the type of speakers,
and the personal preferences of
the listener. These recommen-
dations are not concrete, they
are simply good starting
points.
You’re almost done! Now for the details of operation…
Equalizing the System
11
Installation Hint: For the
absolutely best results, The
Architect ™ Model 560, 735 and
760 should be adjusted with a real
time analyzer such as the
AudioControl Industrial SA-3052.
Example Settings