AudioCodes Mediant 9000 Rev. B, Руководство по установке оборудования

Страница: 29 / 40

Hardware Installation Manual 5. Fiber Network Card Support
Version 7.2 29 Mediant 9000 Series SBC
5 Fiber Network Card Support
This section describes the device's fiber network card support.
Note: Currently, fiber network card support is supported only on Mediant 9080 / Mediant
9000 Rev. B. For fiber network card support on Mediant 9030, please contact your
AudioCodes sales representative.
5.1 Supported Configurations
The network cards located in PCIe slots 1 and 2 (as shown in Figure 3-3), can be replace
with SFP cards in any of the following supported configurations:
Table 5-1: Supported Configurations with SFP Network Cards
Slot 1 Slot 2 Total Network Ports (incl. Slot 1)
Quad 1 GbE Copper Quad SFP+ 10G with LX
transceivers
8 x 1 GbE 4 x 10G SFP+ LX
Quad 1 GbE Copper Quad SFP+ 10G with SX
transceivers
8 x 1 GbE 4 x 10G SFP+ SX
Quad SFP+ 10G with LX transceivers Quad SFP+ 10G with LX
transceivers
4 x 1 GbE 8 x 10G SFP+ LX
Quad SFP+ 10G with SX transceivers Quad SFP+ 10G with SX
transceivers
4 x 1 GbE 8 x 10G SFP+ SX
Note: The Network cards “Quad SFP+ 10G with LX transceivers” and “Quad SFP+ 10G
with SX transceivers” must be ordered from AudioCodes.
5.2 Replacing Copper NIC with Fiber Network Card
If you want to replace the copper NIC with the Fiber Network Card, follow the below
procedure.

To replace the copper NIC with Fiber Network Card:
1. Power off the server and disconnect it from the power source.
2. Disconnect the network cables from the slots to be replaced (slot 2, or both 1 and 2).
3. Extract the PCI-e Riser cards, as described at the following link (see Section “Removing
and Replacing an Expansion Board”):
http://h20628.www2.hp.com/km-ext/kmcsdirect/emr_na-a00019132en_us-5.pdf
4. If you are replacing one card only, replace the Copper GbE card in Slot 2 with the new
fiber card. Otherwise, replace both cards.
5. Connect the optic cables as described in Section 4.5 .
6. Power on the server. When the device finishes loading, the new SFPs are labeled
"GE_9" through to "GE_12" if a single card was replaced, or "GE_5" through to "GE_12"
if both cards were replaced.