AudioCodes 320HD, Руководство администратора

Страница: 88 / 116

320HD IP Phone
Administrator's Manual 88 Document #: LTRT-08108
Parameter Description
voip/dialing/automatic_d
isconnect Determines whether the phone automatically goes idle (i.e. on-hook) when the
last remaining call is disconnected. This is only relevant when the speaker or
headset is used.
ƒ
[0] Disable
ƒ
[1] Enable(default)
Automatic Dialling
voip/dialing/auto_dialing
/enabled
Determines whether automatic dialing is enabled (i.e., phone number is
automatically dialed when you off-hook the phone).
ƒ
[0] Disable (default)
ƒ
[1] Enable
voip/dialing/auto_dialing
/timeout Timeout (in seconds) before automatic dialing occurs after the phone is off-
hooked. When set to 0, automatic dialing is performed immediately.
The valid range is 0 to 120. The default value is 15.
voip/dialing/auto_dialing
/destination
The number that is automatically dialed when the phone is off-hooked.
The valid value can be up to 32 characters.
4.2.6.8 Voice Parameters
Table 4-24: Voice Configuration File Parameters
Parameter Description
voip/audio/jitter_buffer/
min_delay The initial and minimal delay of the adaptive jitter buffer mechanism, which
compensates for network problems. The value should be set according to the
expected average jitter in the network (in milliseconds).
The valid range is 0 to 300. The default value is 35.
voip/audio/jitter_buffer/o
ptimization_factor The adaptation rate of the jitter buffer mechanism. Higher values cause the
jitter buffer to respond faster to increased network jitter.
The valid range is 0 to 13. The default value is 7.
voip/audio/echo_cancell
ation/enabled Enables echo cancellation.
ƒ
[0] - Disable
ƒ
[1] (default) – Enable
Note: Disabling echo cancellation should be done for testing purposes only.
voip/audio/silence_comp
ression/enabled Enables silence compression for reducing network bandwidth consumption.
ƒ
[0] Disable (default)
ƒ
[1] Enable