16
Setting ATW-R3210
Setting the audio output level
1. From the menu screen, turn the control dial, select [AUDIO] and
then press the control dial.
2. Turn the control dial to set the audio output level.
• The level changes 2dB +/- each time you turn the control dial.
• It can be set from -60 to 0dB.
3. Press the control dial.
• The setting is complete.
Scanning for open channels
Scan for unused channels in the current environment for use.
1. From the menu screen, turn the control dial, select [GROUP
SCAN] and then press the control dial.
2. Turn the control dial to select the group you want to scan. After
selecting a group, press the control dial.
3. Turn the control dial to select the preferred threshold. After
selecting the threshold, press the control dial.
• You can select [Normal], [High] or [Low] sensitivity.
High: Prioritize the number of channels.
Normal
Low: Prioritize stable operation.
• Scan starts.
4. Confirm the scan result by selecting [OK] and then pressing the
control dial.
• If you want to scan over again, select [Retry].
5. Available channels and frequencies are shown in a list. Turn the
control dial, select an available channel and then press the
control dial.
• The setting is complete.
Setting transmitters via IR SYNC
This function allows you to make transmitter settings on the receiver
and then automatically configure the transmitter via IR SYNC. The
following are the available settings and setting values:
Settings
Setting values
Freq
Current setting value, NoChange
Name
Current setting value, NoChange
RF Pwr
Low:10mW, High:30mW, NoChange
Gain
-10 to +20dB, NoChange
Lock
Lock, Unlock, NoChange
Batt
Alkaline, Ni-MH, NoChange
HPF
OFF, ON, NoChange
1. From the menu screen, turn the control dial, select [TX SYNC]
and then press the control dial.
2. Turn the control dial to select a setting you would like to sync to
the transmitter and then press the control dial.
3. Turn the control dial to select the setting value and then press
the control dial.
4. Repeat Steps 2 and 3 for each setting you would like to sync to
the transmitter.
5. Turn the control dial, select [SYNC START] and then press the
control dial.
• Communication function is in standby.
Refer to "Using IR SYNC" (p. 25) for subsequent steps.
