Audio Note TT-Three, Руководство пользователя

Страница: 24 / 29

Examine the areas where the belt contacts the platter either side of each motor
pulley. Look for the position of the belt at the platter’s edge at these points. You
should be able to ascertain which suspension tower(s) require adjustment; if the belt
is running low on the platter (below the centre line of the platter), then the suspension
tower at this point needs to be lowered. If the belt is running high on the platter at this
point (above the centre line of the platter), then the suspension tower at this point
needs to be raised. You can also use a spirit level to work out which tower(s) need to
be adjusted.
Once you have identified which towers need to be adjusted, remove the belt and
platter. Looking at the top of each suspension tower, you should see a small locking
nut and the central adjustment screw:
Loosen the locking nut with an appropriately sized spanner, and then adjust the
height of the suspension up or down. Make small adjustments and then replace the
platter and belt to see if more adjustment is required. Once the belt is running at the
central point on the platter edge all the way around and the platter is level, remove
the belt and platter one more time and – while keeping a screwdriver in the slot of the
adjustment screw to stop it moving – tighten the locking nut. Once this is done,
replace the platter and belt, check the belt position and platter one more time, check
that the platter is level with a spirit level, and if all is correct, you may install the
suspension covers and proceed with installing the cartridge.
UNPACKING AND INSTALLATION continued…