Audio Innovate AEM-100i, Руководство пользователя

Страница: 14 / 16

14
REAR PANEL
20V~1A AC IN input from the transformer power supply included with the mixer. ***Please make sure
the correct power supply is plugged in before turning on the power.
POWER Used for turning the unit on and off. The “1” position is on and the “0” position is off.
FADER START Connect a 1/8” mono jack cable (usually included with the CD player) from here to a
fader start compatible CD player to use the Fader Start function. ***Note that audio RCA cables provide
grounding for these signals and must be hooked up to the CD player for this function to work.
MASTER BALANCED OUT Used for high quality XLR connections to the master speakers or amp.
OUTPUT MASTER Used for standard 1/4” RCA outputs to the master speakers or amp.
OUTPUT BOOTH Standard 1/4” RCA outputs to speakers used in the DJ booth. ***Please make sure
that these outputs are not used for the main audio output because the LED meters show the output on the
master line and not on the booth line.
OUTPUT RECORD Line level output used for analog recording. This is the PFL input to both the
Master and Booth outputs. ***Please only use this for recording because there is no master volume
control. The level is properly set for analog recording.
CH1/CH2 Both inputs have Phono/Line switchable, Line, and Aux inputs. The Aux inputs from the
back combine with the Aux inputs from the front. ***If you are using the Phono/Line switchable inputs,
make sure that the Phono/Line switch is set properly or the sound will distort (Line input set to Phono) or
will be too quiet (Phono set to Line). Also, when you use turntables, if the turntables have ground screws,
please make sure to use RCA cables which include an added ground wire for hookup to both the turntable
grounds and the GND pins above the CH1/CH2 inputs.