22
Rev.1.25
Charging a battery
1) Turn off the microphone.
2) Connect the micro-USB plug of the charger to the DC input terminal of the microphone.
After connecting the microphone to the charger, the charge indicator (red) indicates the charging
status as follows:
Blinking
(2 seconds interval lights): Charging
* In the case of a complete discharge state, the LED lights red for the first minute.
ON:
Charging completed / battery is empty / E2 state
Blinking
(500 milliseconds interval lights): Charge Error.
Indicates that the temperature of the
battery may be out of the acceptable range. Return the temperature to normal.
OFF:
Not connected to a charger or no battery is installed.
Important:
• If the microphone is connected to the charger with the power turned on, the microphone will be
powered off and charging will start. Only the E2 buttons operate during charging.
Note:
• If the charger remains connected after charging is completed, it will not restart charging to make up
for any amount lost due to self-discharge.
• If the microphone is turned off and the charger is connected, but the charge indicator does not light,
check to see that the micro-USB plug of the charger is properly plugged into the DC input terminal,
the power cable of the charger into the charger.
• Charging takes up to 4 hours (5V/500mA), but that time varies depending on the status of use.
• Charging at a temperature outside the normal range may take significantly longer to charge.
Note that charging times may become longer even within the operating temperature range, if the
temperature of the microphone is higher or lower than the normal condition.
• The charger and the microphone may get hot slightly during charging.
• Do not charge a rechargeable battery that has just been fully charged. Otherwise you will shorten
the life of the battery.
• Also read the operating instructions of the charger.
･
Do not recommend charging a battery from a computer.
･
Use the charge only Micro-USB Cable. The battery does not fully charge when using the
Micro-USB communication cable.
1.
[PWR/MUTE] button
Charge indicator
DC input terminal
2
Micro-USB plug
(Charge only Micro-USB Cable)
