Step 1
• Insert cap and push screw into the non threaded end of the aluminum bar.
• Using a flat surface, place the two long feet so the ends meet up as pictured below.
Note:
Ensure the curves of the feet are going up when placed on a flat surface.
• Place the short foot on top with the countersink facing up.
• Using the four small screws, attach the feet.
• Place the feet on the end of the aluminum bar with threading, and using the large screw, attach
the feet to the bar.
Note:
Ensure the short foot is facing away from the “T Channel”.
• Place foam pads that are provided in
the location designated.
2
