On Safety
* Operate only on designated AC power supply (120V AC in North America).
* Should any liquid or solid object fall into the cabinet, unplug the unit and have it checked by
qualified personnel before operating it any further.
* Unplug the unit from the wall outlet or set the Master switch to OFF if it is not to be used for
several days.
* To disconnect the cord, pull it out by the plug. Never pull the cord itself.
On Installation
* Allow adequate air circulation to prevent internal heat build-up. Do not place the unit on
surfaces (rugs, blankets, etc.) or near materials (curtains, draperies) that may block the
ventilation holes.
* Do not install the unit in a location near heat sources such as radiators or air ducts, or in a place
subject to direct sunlight, excessive dust, mechanical vibration or shock.
On Repackaging
Do not throw away the carton and packing materials. They make an ideal container in which to
transport the unit. When shipping the unit to another location, repack it as it was originally
packed at the factory.
3
4
1. [MIC/LINE] Input Jack ---
This is a balanced XLR input jack. This
XLR input jack is to be connected to a microphone, a musical
instrument, or an audio device through a balanced XLR cable.
2. [GAIN] Control Knob ---
This knob is used to raise or lower the gain
level of the input signal. There are two sets of gain control dB
numbers. The lower sets of dB numbers are for the microphone
signal level control while the higher sets of dB numbers are for
the audio signal level control. When the audio level is higher
than a predetermined threshold, the [PEAK] LED indicator
(refer to numeral 10) will keep blinking until the audio level goes
below the threshold.
3. [HIGH] Treble-tone Control Knob ---
This knob is used to adjust the
gain for the input signal band centered at 12.5KHz in the range
from -15dB to +15dB.
4. [MID] Alto-tone Control Knob ---
This knob is used to adjust the gain
for the input signal band centered at 2.5KHz in the range from
-15dB to +15dB.
5. [LOW] Bass-tone Control Knob ---
This knob is used to adjust the
gain for the input signal band centered at 80Hz in the range from
-15dB to +15dB.
6. [AUX1] Control ---
This control adjusts the level of the input sent to
the AUX1 output (refer to numeral 4 in section MAIN TERMINALS
on page 6).
2
REAR PANEL
1
3
4
5
6
