Audica CS-SERIES, Руководство пользователя и технические характеристики

Страница: 9 / 13

9
GB
Assembly of Speakers and Accessories
To attach the base to the CS-T1
floor standing speaker (CS-
System 3 only) follow the
diagram (right).
1. Lay the speaker down on a
soft surface and offer the base
plate up to the bottom of the
speaker.
2. Make sure the threaded
studs on the speaker protrude
through the corresponding
holes in the plate.
3. Place the washers over the
studs and screw on the bolts
using the spanner provided.
4. To attach the spike
assemblies, screw the spike
into the threaded holes in the
bottom of the plate. The height
of the spikes can be adjusted by
turning the small part of the
spike clockwise for increasing
and anti-clockwise for
decreasing the height.
DO
NOT OVER TIGHTEN.
To use the wall bracket provided
with each satellite, follow these
instructions.
1. With the plastic cover
removed and the speaker in
place, decide where you wish to
mount the bracket.
2. Mark the positions of the
screw holes on your wall using a
pencil.
3. Remove the speaker from the
bracket and attach the bracket to
the wall.
4. When the Bracket is mounted
in place then the plastic trim can
be snapped over the metal plate.
NOTE: We do not provide
fixing for the bracket as wall
materials and conditions are
not always the same. We
recommend using appropriate
wall plugs and at least No 4 x
25mm screws for a secure
mounting.
+
+
1,2 3,4
1,2
3,4