Audica CS-SERIES, Руководство пользователя и технические характеристики

Страница: 7 / 13

7
Speaker Connection
The should be
wired up as shown (left). To
prevent speakers being wired out
of phase, always use the printed
strand (3) for the positive red
terminal (1) on both the speaker
and the amplifier. Dress the
cables out of the rear of the
speaker through the aperture in
the terminal panel.
LCR Speaker
+ LH + RH
+ CEN
DESIGNED
IN THE EU
MADE IN P.R.C
MODEL No
CS-LCR
FREQUENCY
80Hz-23KHz POWER HANDLING
60W-100W
IMPEDANCE
4 Ohms
T
O
SPEAKERS
T
O
SOURCE
T
O
SPEAKERS
T
O
SOURCE
1
3
Speaker connection can be made easier and safer by following a few easy steps.
1. Always have your equipment turned off at the mains before connecting or disconnecting speakers.
2. Lay your cables out to the points where you plan to place your speakers before cutting them to length remembering to allow for the height of
stands or wall mounting. For best results, make sure the left and right cables are the same length.
3. Connect your cables to the speakers before fixing to stands or wall brackets.
4. Always connect the printed side of the cable to the positive or red terminal.
5. Only insert the exposed stripped metal into the terminal post. Inserting the cable too far may result in the plastic sleeve avoiding a proper
connection.
6. Check all connections at the speaker and amplifier end before turning on your system. Connecting the cables incorrectly could short out your
system and damage your equipment.
T
O
SPEAKERS
T
O
SOURCE
T
O
SPEAKERS
T
O
SPEAKERS
T
O
SPEAKERS
T
O
SPEAKERS
+
T
O
SPEAKERS
FL FR SL SR CEN
Amplifier rear panel (actual panel may differ)
CS-System 1 - CS-LCR (FL,FR)
CS-S1 (SL, SR)
CS-System 1 - CS-LCR (CEN)
+ + + +
GB