Audi TT 2015, Руководство пользователя, Страница: 265 / 300

0
N
co
.....
\D
IJl .....
\D
.....
(such as tiles) use a rubber mat or similar to
prevent the jack from slipping c:> ,&. .
� Locate the marking on the door sill closest to
the wheel being changed c:>
Fig. 234.
The jack­
ing point is located behind the marking under
the door sill.
� Wind up the jack* under the jacking point until
the claw @ c:>
Fig. 235
of the jack is directly be­
low the jacking point.
� Align the jack* so that the claw
@ grips the
jacking point under the door sill and the mova­
ble base plate of the jack @ is flat on the
ground. The base plate ® must be positioned
vertically underneath the jacking point @ .
� Raise the vehicle until the defective wheel is
clear of the ground.
A
WARNING
-Make sure the jack* is stable. If the ground
underneath the jack* is slippery or soft, the
jack can slip or sink in - risk of injury!
- Use only the jack* supplied with your vehicle
to raise the vehicle. If you use a jack from a
different vehicle, your vehicle may slip off
the jack - risk of injury!
-Apply the jack* only at the jacking points lo­
cated behind the markings on the door sill
and align it properly. Otherwise there is a
risk of injury since the jack* can slip off sud­
denly if it is not properly engaged.
-The height of the parked vehicle can change
as a result of variations in loading.
- Never start the engine when the vehicle is
on the jack - risk of accident!
-If work has to be done under the vehicle, en­
sure that it is safely supported on suitable
stands - risk of injury!
CD
CAUTION
The vehicle must not be lifted up on its sills.
Only apply the jack* at the jacking points loca­
ted behind the markings on the door sill. Oth­
erwise your vehicle could be damaged.
Mobility
Taking off/ putting on the wheel
Fig. 236
Wheel: Hexagonal socket for turning wheel bolts
Fig. 237
Wheel: Mounting pin in wheel bolt hole nearest
to the top
Taking off the wheel
� Using the hexagonal socket in the screwdriver
handle (provided in the vehicle's tool kit), un­
screw the top wheel bolt and place it on a clean
surface c:>
Fig. 236.
� Screw in the mounting pin (provided in the ve­
hicle's tool kit) by hand in place of the wheel
bolt c:>
Fig. 23
7.
� Then unscrew the other wheel bolts.
� Take off the wheel c:>(D. The mounting pin
stays where it is.
Putting on the wheel
When putting on a tyre with directional tread
pattern, refer to c:>
page 264.
� Put on the wheel, using the mounting pin to
guide it into place c:>(D.
� Screw in the wheel bolts and tighten them
lightly using the hexagonal socket.
� Then unscrew the mounting pin and tighten the
remaining wheel bolt lightly.
� Carefully lower the car with the jack*.
� Tighten the wheel bolts in diagonal sequence
with the box spanner. ..,..
263