Audi 100 Quattro, Руководство пользователя

Страница: 48 / 180

CONTROLS AND EQUIPMENT
46
4 – Speedometer/Odometer
The speedometer indicates road speed.
The odometer indicates the distance
driven.
USA models: Miles
Canada models: Kilometers
To record a distance, reset the
trip
odometer to zero by pressing the button.
The last digit in red indicates 1/10 of a
mile or kilometer.
5 – Fuel gauge
The needle in the fuel gauge will indicate
the fuel level in the tank shortly after the
ignition is turned on or the engine is
running.
The fuel tank capacity is 21 gal/80 liters.
When the needle reaches the red area,
there is a reserve of 3.2 USAgai/12 liters
of fuel left in the tank. Time to refuel.
6 – Engine oil temperature gauge
Engine oil temperature is measured in
degrees Celsius from 60 °C (140 °F) to
170 °C (338 °F). With needle around
60 °C, do not accelerate under full load.
If the needle moves into the upper zone
in exceptional cases, the engine speed
must be reduced. The needle should
then return to the normal zone.
If the needle stays in upper zone, stop
the vehicle, switch off the engine and
check the oil level. If the oil level is
correct and the oil pressure warning light
does not flash when the engine is
started, you can drive on to the next Audi
dealer but do not run engine at high
speeds.
7 – Engine oil pressure gauge
Oil pressure in the engine is shown in
bar. Should engine oil pressure drop
suddenly (below 1.8 bar) while driving, a
warning light will flash or three warning
tones will sound and the oil pressure
warning light in the Auto-Check System
will flash.
Pull safely off the road and stop.
Let the engine cool down before
checking the engine oil level. Add engine
oil if necessary.
If engine oil pressure does not return to
normal, do not continue to operate the
vehicle. Have your Audi dealer locate
and correct the cause promptly.
8 – Voltmeter
The voltmeter in the instrument cluster
shows the voltage for the vehicle's total
electrical system. The normal reading
should be between 12 and 15 volts. If the
voltage should drop below 12 volts while
the engine is running, have the electrical
system (battery and alternator) inspected
by your Audi dealer. See also pages 49
and 55.
When starting your vehicle, the voltage
may drop below 8 volts.
9 – Instrument illumination
With the lights switched on, you can
adjust the brightness of the instrument
panel and the center console by turning
the knob in the instrument cluster located
next to the coolant temperature gauge –
see page 44.
10 – Warning/indicator lights
see page 47,
11 – Auto-Check System
see page 52.
12 – Trip computer
see page 56.