2
design for kitchen applications, the controller has a limited ability to dissipate the
heat generated by the internal solid state relay during the initial heat up process.
The initial full power heat up process cannot be more than 90 minutes. If you have
a pot that is larger than
5 gallons (19 litters), please read Appendix 1 “Managing
the heat generated by the controller
”
Always place the sensor in the controlled subject when the controller is on. Before
turning on the controller, please make sure the sensor is placed inside the
container to be controlled. Leaving the sensor outside of the solution will form an
open loop operation. If the sensor is left outside, controller will assume the
temperature is low even if the controlled subject is already very hot. The controller
will provide full power to the heater which will not only overheat the controller but
also damage your appliance, possibly causing a fire.
The 16 AWG power cord provided with your controller is specially designed for
high power applications. Do not replace it with a regular computer power cord
when the heating/cooking device is more than 1200 watts.
This controller is designed to control the devices recommended by Auber
Instruments only. Using it to control a not recommended device can be dangerous
and cause fires. Auber Instruments is not liable for damages caused by misuse of
the controller. If you are not sure the controller can be used, please contact Auber
Instruments before use.
If an abnormal display or noise is observed, turn the controller off, unplug the
power cord and contact the manufacturer before using it again.
Clean the controller only when it is cool and unplugged.
Do not allow children to operate the controller.
Specifications
Input voltage:
100 to 240 VAC 50 /60 Hz
Output voltage:
Same as the input.
Maximum Current:
12A at 120V, 10A at 240V
Fuse Size:
15A Fast blow.
Controller Mode:
PID, PI, PD or P.
Output switching device:
Built-in optically isolated solid state relay with zero voltage
crossing switching.
Sensor tip dimensions:
4 mm diameter x 40 mm long.
Sensor cable length:
5 ft (1.5 m)
Timer Range:
0.1 to 99.9 hours for each step, 6 steps total
Temperature resolution:
1 °C or 1 °F
Temperature display range:
-10 to 200 °C or 14 to 392 ° F
Temperature control range:
+5 °C (°F) from room temperature to 195 °C (383 °F)
Temperature accuracy:
±1°C (±2°F)
Dimension:
6.5 x 3 x 5.2 inch (170 x 80 x 135 mm) W x H x D.
