ATX VersAtive Pro Mondo, Руководство по аппаратному интерфейсу

Страница: 18 / 22

CHAPTER 3: STARTUP
3-2 VersAtive
®
Pro Mondo – Hardware Interface Manual
3.4 Streaming Network Configuration
NOTE:
It is important to set the eth1, eth2, eth3, eth4 and eth5 streaming ports to subnets
different from the MGMT port to avoid flooding the control network with streaming content.
Each transcoder Node has five Ethernet interfaces on the rear panel for streaming, Table 3.4a and Figure 3-3 . All 5 Streaming
or Publishing ports are identical in operation. To connect the transcoder use straight wired cables to a router or switch.
Table 3.4a: Ethernet Ports
Port Description
MGMT Management port eth0 used to configure the transcoder. Not used to connect streaming content.
eth1 Streaming or publishing exclusively for IP based streaming content..
eth2 Streaming or publishing exclusively for IP based streaming content..
eth3 Streaming or publishing exclusively for IP based streaming content.
eth4 Streaming or publishing exclusively for IP based streaming content.
eth5 Streaming or publishing exclusively for IP based streaming content.
IPMI DHCP enabled hardware level interface for transcoder management supporting IPMI LAN 2.0.
Note: Please refer to the VersAtivePro Operation Manual for programming guidance.
Figure 3-2: Transcoder Nodes with Unique MGMT IP Addresses Assigned
eth2 eth3 eth4 eth5
Node A
Node B
Node C
Node D
eth2 eth3 eth4 eth5
eth1
eth1 eth1
eth1
eth2 eth3 eth4 eth5 eth2 eth3 eth4 eth5
Publishing Interfaces
Publishing Interfaces
Publishing Interfaces
Publishing Interfaces
Figure 3-3: Transcoder Nodes Publishing Interfaces