ATX VersAtive Pro Mondo, Руководство по аппаратному интерфейсу

Страница: 17 / 22

CHAPTER 3: STARTUP
VersAtive
®
Pro Mondo – Hardware Interface Manual 3-1
STARTUP
3. Startup
Each of the four Nodes in a Mondo chassis are factory configured identically. It is important to understand that the standard
ATX Networks default IP address of 192.168.0.23 for the MGMT port is assigned to all nodes. Before connecting each node
to the management switch, the IP addresses must be re-configured for your network.
This section describes how to set the Management PC to the same subnet as the transcoder subnet then set the Ethernet
port to the required address.
NOTE: This equipment must have default MGMT port IP addresses changed from 192.168.0.23
before operation is initiated.
NOTE: It is important to connect the eth1, eth2, eth3, eth4 & eth5 streaming ports to a GbE
capable switch or risk uncontrolled continuity errors as the 100 Base-T network is flooded.
3.1 Chapter Contents
• “Management Computer”
• “Connecting to Your Computer”
• “Streaming Network Configuration”
3.2 Management Computer
It is required that the Management Computer meet these minimum requirements.
• Wired Ethernet network port.
• Web browser for Management GUI on 192.168.0.23.
3.3 Connecting to Your Computer
The Mondo chassis is four independent transcoder Nodes each with MGMT network ports factory assigned identical IP
addresses 192.168.0.23 , Figure 3-1 .
These identical IP addresses must be changed to unique addresses before connecting to the management switch as shown
in Figure 3-2 where we show Node IP addresses assigned sequentially.
Node A
Node B
Node C
Node D
Node A MGMT
192.168.0.23
Node B MGMT
192.168.0.23
Node D MGMT
192.168.0.23
Node C MGMT
192.168.0.23
Figure 3-1: Rear Panel MGMT Ports - Identical IP Addresses