CHAPTER 7: RF SETTINGS TAB
7-2
MDU Solutions
®
– UCrypt
®
IP to Analog 2
nd
Generation – Installation & Operation Manual
7.3 Select Active Channel Plan
An analog output RF Channel Plan must be selected from the choices available on the RF Settings tab.
Procedure
This procedure explains how to select the active Channel Plan and Video Standard.
1. Click
RF Settings
tab if it isn’t already selected, Figure 7-2.
2. Select the appropriate
Video Standard
from the drop down list.
3. Select the corresponding
RF Channel Plan
from the drop down list.
4. Click the
Enable VITS
switch if you wish to have Vertical Interval Test Signals inserted on these analog channels.
5. Click
Save
.
6. The active plan is indicated by a green indicator adjacent the plan.
7. It is necessary to
Publish
changes made to the Plan on the Channels page. Click the
Channels
tab,
8. The Publish button shows ‘
1 change is waiting to be published
’. Click the
Publish Button
. This applies the change
to the Device.
9. After publishing, a reboot may be required and a prompt is presented if it is required. Click the link
Reboot Required
.
10. You will be taken to the
System
page for a reboot. In the Power section, click
Reboot
After reboot, the new RF Channel Plan will be in effect.
1
2
3
4
5
6
Figure 7-2: Select Analog Channel Plan
7
8
9
Figure 7-3: Channel Plan Published
9
Figure 7-4: Reboot After Channel Plan Published
