18
Atwell International Limited
Mechanical Installation
For information on mechanically installing the ROPE BRAKES please see the
specific documentation for the individual items as supplied.
Please note this device is a precision encoder device and is not capable of
withstanding a drop or severe mechanical shock, so never use a hammer to
adjust it.
It is also sealed, there are no user adjustable or repairable parts inside it, all
warranties will be void and the product will be destroyed if you open it. If you
suspect it is faulty then replace it, return to Atwell International who will inspect it
and will supply a replacement unit if it was found to have failed under warranty.
Securely bolt the brackets supplied to the tapped holes provided in the rope
brake side bars, adjust backward or forward for
slight tension
against the rope.
It may be necessary to adjust the alignment of the wheel to the rope. This is done
by carefully unscrewing the M4 cap head retaining screw on the wheel, and then
sliding the wheel so the rope is centred on the wheel. Re-tighten the M4 cap
headscrew onto the shaft.
Check for smooth operation and no excessive play or run out.
Connect the other end of this sensor cable to the UMD-SRB01 panel via the 32
way connector, if you have not done so yet.
Slight pressure only.
Allow further movement
on springs. Do not adjust
it so that the springs are
coil bound.
Connect sensor cable
to the sensor box.
M4 Screw
