ATTO Technology ATTO XstreamCORE FC 7550, Инструкция по установке и эксплуатации

Страница: 14 / 41

Configure the XstreamCORE
To configure the ATTO XstreamCORE , use the ATTO XstreamVIEW™ System Manager GUI. Default values are appropriate for most
configurations, but may be modified.
The best way to access the XstreamCORE to view and change
settings is to use ATTO XstreamVIEW™ Sys tem Manager, a
browser-based graphical interface. Other methods are also
available. Refer to
Interface Options.
Help is available from within XstreamVIEW™ by clicking on
the text indicating each setting. For more information on any
of these parameters, refer to the specific CLI command in
Command explanations .
To change mapping, refer to Map Devices.
To use Email notification or SNMP, refer to Remote
Monitoring, Management .
You may make changes to several pages before going to the
Restart page and restarting the XstreamCORE to save the
changes.
Preliminary steps
1. If you are not already in the
XstreamVIEW™ interface, type
the IP address of your
XstreamCORE in a standard
browser as found in
Using
XstreamVIEW™ System
Manager , click Enter Here , type
in your user name and
password, and click
OK .
2. The Status page appears. Check
default settings to ensure they
are appropriate for your
configuration. Use the individual
pages listed on the side menu to
make setting changes or to
configure features.
Port configurations
1. Follow the Preliminary steps .
2. Click on the port you wish to configure on the left hand
menu:
Ethernet, Serial Port or Fibre Channel .
3. Select the parameters you wish to change.
4. Click Submit .
5. If you have completed all changes for this session, go to
the
Restart page and restart the intelligent Bridge.
Modify passwords
1. Follow the Preliminary steps .
2. From the side menu select Controller . The intelligent
Bridge Configuration page is displayed. The Administrator
user name that you are currently logged in with and the
current read only user name, if present, are displayed in
their text boxes.
3. Enter the Administrator (Admin) password where
indicated.
4. Enter appropriate information into the New Admin
Password, Confirm New Admin Password or New Read
Only Password and Confirm New Read Only Password
text boxes.
5. Click Submit .
6. If you have completed all changes for this session, go to
the
Restart page and restart the XstreamCORE.