37 |
P a g e
SerialNumber
Reports the XstreamCORE serial number. The serial number,
unique for each XstreamCORE, is a 13-character field. The first
seven alphanumeric characters are an abbreviation of the
XstreamCORE name while the remaining six numbers are the
individual XstreamCORE board’s number.
get SerialNumber
SerialPortBaudRate
SerialPortBaudRate configures the baud rate for the RS-232 serial
port. The number of data bits per character is fixed at 8 with no
parity.
Default: 115200
set SerialPortBaudRate [ 9600 |19200 | 38400 | 57600 |
115200]
Requires a SaveConfiguration Restart command
get SerialPortBaudRate
SerialPortEcho
Control/reports the status of the display of keyboard input. When
enabled, all non-control character keyboard input is output to the
display. Local ASCII terminal (or terminal emulator) echo settings
should be set to disabled while using SerialPortEcho enabled
Default: enabled
set SerialPortEcho [enabled | disabled]
Requires a SaveConfiguration Restart command
get SerialPortEcho
SNMP
Controls whether or not SNMP functions on the XstreamCORE.
Default: disabled
set SNMP [enabled | disabled]
get SNMP
SNMPDumpMIB (Immediate, Supported In-Band)
Dumps the contents of the specified private SNMP MIB to the
current CLI session. If no parameter is specified, the Controller
private MIB is dumped. For further assistance with SNMP, consult
your network administrator.
Usage: SNMPDumpMIB <Controller | Product | SMI | TC>
SNMPExtendedTraps
Controls Extended SNMP trap functioning such as device
transition and device error. Consult your network administrator
for further assistance with SNMP.
Default: disabled
set SNMPExtendedTraps [enabled | disabled]
get SNMPExtendedTraps
SNMPTrapAddress (OEM Configurable, Disabled on Error)
Sets and displays IP Trap Addresses and Trap Levels. "Index" is a
value from 1 to 6. "IPv4 address" is the host that wishes to
receive traps. "Level" is the severity level required to trigger a
trap: "None", "All", "Warning" (all warning and critical traps
shall be sent), "Critical" (only Critical events shall trigger a trap).
Usage: set SNMPTrapAddress [index] [IPv4 address] [level]
get SNMPTrapAddress <index | All>
SNMPTraps
Controls SNMP trap functions.Consult your network
administrator for further assistance with SNMP.
Default: disabled
set SNMPTraps [enabled | disabled]
get SNMPTraps
SNTP
Controls whether the XstreamCORE contacts a specified SNTP
time server to initialize or synchronize the time.
Default: enabled
set SNTP [enabled | disabled]
Requires a SaveConfiguration Restart command
get SNTP
SNTPServer (OEM Configurable, Disabled on Error)
SNTPServer sets/displays the IP addresses used to retrieve the
SNTP time. Index range is 1-3 indicating the server slot to
set/display. Enter 0.0.0.0 to disable a time server slot.
Usage: set SNTPServer [Index] [IP address]
get SNTPServer <Index | All>
