0
0
10
10
50
50
20
20
40
40
30
30
Input Shaft End-Play Should Be
0.3 - 0.5 mm (.012" - .020")
TRANSMISSION DISASSEMBLY (CONT'D)
5. Install dial indicator on transmission, as shown
in Figure 42, with the plunger against flat spot
on the input shaft.
6. Zero dial indicator and move the input shaft in
and out to measure end-play.
7. Record measurement for assembly reference.
End-play should be 0.3-0.5mm (.012"-.020").
8. Rotate transmission so that output shaft yoke is
facing up, as shown in Figure 43.
Caution: Drain pan may be required under
transmission to catch fluid.
9. Place the transmission in the Park position to
prepare for removal of the output shaft nut.
10. Remove the output shaft drive yoke retaining
nut, using a 30 mm, 12 point socket, as shown
in Figure 43.
11. Remove the output shaft drive yoke, as shown
in Figure 43.
12. Remove and discard the transmission rear seal,
as shown in Figure 43.
Continued on Page 41
Figure 42
Figure 43
434 REAR TRANSMISSION SEAL.
435 OUTPUT SHAFT THRUST WASHER.
436 OUTPUT SHAFT DRIVE YOKE.
437 REAR DRIVE YOKE RETAINING NUT.
434
435
436
437
13. Remove the transmission output shaft washer, as
shown in Figure 43.
Note: Tag the washer, or tie-wrap it to the yoke
since it is very similar to the geartrain end-play
shim and they "must not" be interchanged.
40
Copyright © 2009 ATSG
Copyright © 2009 ATSG
AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
WWW.ALL-TRANS.BY
