ATS HGL 120, Инструкция по эксплуатации и техническому обслуживанию

Страница: 36 / 48

3. REMOTE CONTROL (SPECIAL APPLICATION): this special mode is
generally used to save energy in special application when -
40 °C is not really
required.
The dryer will keep the timed sequence constant but it will switch on and off
depending on the external contact connected on controller.
5.3 SET-UP
To set the dryer up, turn it on.
To enter or exit SET MENU press
button for 3 seconds.
After that the display will show first
P1 , then the default value of P1 03.
To scroll down the menu keep the button
pressed.
To change the value use
“up” and “down” buttons.
To confirm the change press
for 3 seconds. The display will show SA .
To set default parameters keep
“up” and “down” pressed for 3 seconds. The display
will show dF .
PARAMETER TABLE
Parameter Default Min. Max. STEP UNIT
REMARKS
P1 3 1 99 1 10*s
Value of repress ration, shown in tens of seconds.
Example 3=30 seconds
P2 24 6 36 1 10*s
Value of drying and purge, shown in tens of seconds.
Example 24=240 seconds
P3 -39 -80 +20 1
°C
SETPOINT value; the minus sign is shown by the
lowest decimal point blinking (39. means -39)
P4 0 0 3 1
CONTROL MODE; selects the CONTROL MODE
during OPERATING MODE.