13
Test Type
Used to select what type of test to run. The “Timed Test” will run until a time period is finished. The “Indefinite
Test” will run until the specimen breaks or the operator stops the test.
Unload at End of Test
This checkbox tells the system to unload the sample at the end of a test.
IP Address
Used to allow someone at a remote location to monitor the system using a VNC viewer program.
Current Time
Allows the operator to set the current time of the system. This time is used in any log files.
Start Delay
Used to allow the system to be set up to start the cycle automatically after a time delay. You can think of it like
a “coffee timer”. Just enter the Hours and Minutes you wish to wait before start and press the yellow button.
The button will light to show that a delay has been set. The delay button is a toggle switch, so to turn off a
delay that has been started just press the button again. Note the status of the system will show “Delay Start”
when it is active and the remaining time before start is shown.
Done Button
Will return you to the Main Screen.
MAN -
PLC
Lever Arm Tester - REV: 01
| E. Software Overview
Figure E.9: View Screen
