Atom Gasoline Powered Tiller, Руководство пользователя

Страница: 6 / 16

FIG 15B
FIG 15A
FIG 14
FIG 11
SAFETY
INTERLOCK
THROTTLE
TRIGGER
SWITCH
FIG 13
Place Tiller on ground in horizontal position See Fig. 14 below.
COLD START
1. Switch engine on (Fig 11).
2. Slide choke lever up to full choke position (Fig. 12).
3. Press and release the primer bulb
5-8 times (Fig. 13).
4. Make sure you have a firm footing. Hold down motor with left hand. Put
one foot lightly on cross brace. With right hand pull the starter grip slowly
until you feel it engage – and then give it a pull (Fig. 14).
5. When engine starts to run allow it to run on half choke for a few seconds to
warm up, then push choke down to engine run position.
6. Throttle Trigger (engine accelerator control is operated by pushing down
interlock with thumb and pulling on trigger (Fig. 11).
STARTING & STOPPING INSTRUCTIONS
6
COMBINATION CULTIVATING, TILLING, ROTARY HOEING
1. The Atom Tiller is very easy and simple to use. It only
takes a few minutes to become an efficient user.
2. Thoroughly inspect the area where the tiller is to be
used and remove all long grass, stones, sticks, wires
and other foreign objects.
3. Adjust tine depth (Fig. 15(a)(b). Try the third hole closest
to operator.
4. Start motor.
5. With both arms fully extended downwards, (Fig. 15C),
hold both handle grips firmly. With the engine running,
pull the throttle trigger full on after depressing safety
interlock. Engine must run at three quarter to full speed
for best tilling results.
6. As tilling action begins, the tines dig and move the tiller
forward.
7. NOTE : to reduce “Forward Pull” of tiller, adjust wheel
arm for shallow depth.
8. Continue at a moderate pace until you are familiar with
the controls and handling of the Atom Tiller.
NOTE : after allowing the tiller to cultivate 500mm you
can pull it back towards you and then allow the unit to
move forward again. You can repeat this procedure
over the area you are cultivating. Always have a firm
footing.
9. Mulching. The tiller is ideal to mix, cut lawn clippings,
leaves etc into your garden bed. This method accelerates
mulching/composting process.
10. To go deeper adjust wheel arm adjustment forward or lift
handles. To go shallower adjust wheel arm adjustment
rearwards or push handles down.
HOT OR WARM START
7. Switch ignition on and follow instruction
3 & 4.
FLOODED ENGINE
8. Ignition ON, choke lever in run
position.
9. Pull starter rope up to 10 times to clear
excess fuel.
10. If engine has excessive fuel that cannot
be cleared, remove spark plug from
engine and from spark plug terminal,
crank engine to clear excess fuel, wipe
and dry spark plug of all fuel, re-install
spark plug terminal, and restart as
above. Otherwise allow to stand for 30
minutes before restarting.
FIG 12
FIG 15C