Atom Gasoline Powered Tiller, Руководство пользователя

Страница: 5 / 16

FIG 9B
FIG 9A
FIGURE 7A
Insert 175mm(6
1
/
2
”) bolt #2 thru the
head retainer #3 (note arrow points
forward) then thru handle tube #1
then thru AV Rubber #12 then thru
Tiller body #4, thru AV Rubber #12
and handle #1.
Screw large wing nut #6 on
protruding bolt and tighten.
Fit cross brace #7 to handles #1 &
#5 with base down as illustrated.
Use 2 screws #8 and lock nuts #9
provided in packet. Use straight
bladed screwdriver (or torx 25
screwdriver) screw on firmly.
NOTE : Throttle cable and switch
wire from engine must be fitted
under engine and Tiller body and
along side cross brace. Clip into
place, back to throttle trigger.
FUEL MIX – 2 STROKE ENGINES
USE AN OIL AND GASOLINE MIXTURE
IMPORTANT
Two-cycle fuel separates and ages. Do not mix more
than you will use in a month. Using old fuel can cause
difficult starting or engine damage. Shake fuel container to
thoroughly mix fuel before each use. Do not attempt to run
your engine on gasoline only; this will cause engine failure
and void engine warranty.
Do not use outboard engine motor oil. Only use specialised
2-stroke oils from lawn and garden equipment shops.
Remember …
• Always mix two-cycle oil with gasoline before fueling
your tiller. Never, ever run your tiller on gasoline alone.
This will ruin your engine and void all warranties.
• Always use a clean gas can and always use unleaded
gas.
• Never try to mix the oil and gasoline in the engine fuel
tank.
• Always mix oil and gas in the proper proportions: 125ml
of two-cycle engine oil to 4 litres of unleaded gasoline
Fig. 9A.
PLEASE READ SAFE FUELLING INSTRUCTIONS – Page 3
5
ASSEMBLING THE
lll
ATOM TILLER
FUEL & OIL – 4 STROKE ENGINES
DO NOT USE OIL AND GASOLINE MIX ON
4 STROKE ENGINES
1. Use clean, fresh unleaded gasoline.
2. Use clean engine manufacturers recommended oil (see
seperate booklet supplied with 4 stroke engine supplied) or
SAE 10-30W synthetic oil. Fill crankcase to correct level.
WARNING
using non synthetic oil or 2 stroke oil will shorten
engine life.
3. ALWAYS check your oil every second or third fill. Regular
check of oil levels is essential. Change oil after first hour
then every 6 hours. Lack of oil and infrequent change of
oil will destroy engine.
4. With some tillers, lay tiller on side to fill with gasoline
Fig. 9B.
FIG 7B
Insert Trigger Handle #10 onto right handle tube #5 using one screw #8 one nut #9
Fig. 7B. Clip cable into place.
Insert left handle #11 into left handle tube using screw #8 and nut #9 screw on firmly.
Clip on cable clamp with throttle cable and switch wire as shown #13 Fig. 7A.
Attach wheel arm axle #14 through large hole in Tiller body. Use bolt #15 and washer #16
and screw into wheel arm axle and tighten.
FIG 8
UPPER OIL LEVEL
OIL FILLER NECK
ENGINE OIL FILLER CAP
HONDA ENGINE SHOWN
FURROW PLOW
ATTACHMENT
Refer p.15.
FIG 7A