E M P T Y F L U I D T A N K - P U R G E M O D E
Your machine is equipped with a low fluid sensor that prevents the machine from operating with an
empty fluid container. If your machine happens to run out of fluid, follow the steps listed below.
IMPORTANT: During Purge Mode, vapor will exit the output nozzle for up to 30 seconds. For your
safety, personal protective equipment is recommended during operation.
“ PURGE MODE”
The machine will begin to purge fluid, and vapor will release from the
output. Once the cycle is complete, you are ready to Atmosclean™.
“ UH OH, EMPTY FLUID TANK!”
Disconnect the container, and refill with Atmosclean Vapor Sanitizing
Solution™.
“ HOLD ENTER TO START PUMP”
Reconnect the fluid container using the quick dissonnect, then press
and hold the enter button for three seconds.
STEP 1
STEP 2
STEP 3
4
FOG OUTPUT: The “fog output” determines the volume of vapor dispersed during
operation.
Your machine comes set at 50% output from the factory, it is not reccommended to
go any lower than 50%. However, for bigger spaces, you may need to increase the
output. To increase the volume of vapor, scroll through the menu (far left button)
until you see “fog output”, and use the up arrow to select your output percentage.
When finished press the enter button to confirm your selection.
