1
8
3.0 Assembly
3.3
Installation of the module
•
Position the module.
•
Secure the module with 2 screws (051.0299.0) on the
bottom side.
•
Guide the ribbon cable from the camera (
1
FIg. 10)
along the right side of the cabinet.
•
A small adapter board 531.2141.0 is integrated in the
ribbon cable
•
Connect the camera cable to the PCB (Fig. 11).
•
Guide the control cable for the grip control of the strobo-
scope light source towards the back, by leading it through
the middle of the cabinet opening on the rear side of the
module (Fig. 14).
•
Pull the cable gland over the cable and fi t it into the ope-
ning.
•
Connect the cable for the grip control to the corresponding
jack on the rear side of the Strobo LED (Fig 12, Fig 16).
Fig. 10
Connection of the camera
on the control PCB
Fig. 11
Fig. 12
