121
SAMA5D3x-EK User Guide [USER GUIDE]
11180B–ATARM–29-Oct-13
8.
Revision History
Table 8-1.
Revision History
Document
Comments
Change Request
Ref.
11180B
Changed document layout, including section numbering. Changed Embest to
Embest/Flextronics throughout document.
In
“Introduction”
and
“Contents”
: Added SAMA5D36, SAMA5D36-EK and
SAMA5D36-CM to lists of available references and to information for display
modules (DM). Also throughout document.
In
Table 1-1 “Evaluation Kit Specifications”
, removed information on
temperature and relative humidity. Added information on CE and FCC
compliancy. Added SAMA5D36-EK.
In
Table 4-1 “CM Board Implementation”
, updated boards available from
manufacturers.
In
Table 4-2 “CPU Module Specifications”
, removed ‘optional’ from details on
NOR in Memory row.
In
Section 4.2.3 “Configuration Items”
, removed “Dual ON/OFF switch for
NAND Flash” and replaced with “One jumper for”.
In
Table 4-3 “Boot Options”
, in row BMS OPEN: Added “...followed by:” after
“ROM Boot” and added SAM-BA after TWI in column Type. In column Note,
changed “Default boot on embedded ROM” to “Default boot is from embedded
ROM”. In row BMS CLOSE, changed “Boot on external NOR Flash memory”
to “Boot from external NOR Flash memory”.
Section 4.2.4.1 “Boot Configuration”
: Revised throughout.
Section 4.3.3 “Reset Circuitry”
: Changed information on JTAG reset.
Section 4.3.6 “Serial Peripheral Interface Controller (SPI)”
: Revised
throughout.
Section 4.3.9 “Indicators”
: Removed specific information on red and blue
LEDs. Added information on control by GPIO lines.
Added
Section 4.4.2 “CPU Module Revision E Schematics”
.
Table 5-1 “MB Technical Specifications”
, Mass Storage Interface: Updated
information on all types of cards supported.
- Added information on RoHS and CE and FCC compliancy.
- Removed temperature range information.
Section 5.2.3 “Debug JTAG/ICE and DBGU”
: Modified details of ATSAM3U4C.
Section 5.2.3.1 “Disabling J-Link-OB-ATSAM3U4C”
: Revised throughout.
Section 5.2.3.2 “Hardware UART via CDC”
: Revised throughout.
Section 5.2.4 “USART”
: Revised throughout.
Section 5.2.6 “Ethernet 10/100 (EMAC) Port”
: Revised throughout.
Section 5.2.10 “CAN Bus”
: Removed mention of two ports for connector J27.
Section 5.2.14 “LED Indicators”
: Revised throughout.
Section 5.2.15 “Pushbutton Switches”
: Changed fourth bullet.
Added
Section 7.1 “Errata”
with
Section 7.1.1 “Impedance Mismatch on
Revision C of the SAMA5D3x Main Board”
.
9364
9364
9363
9360
9363
9364
9363
9360
8803
11180A
First issue
