4
Testing the ATSTK94
2449A–FPSLI–01/02
If your design does not run immediately you can set
JP19
to
RESET
and use the
RESET
button
SW12
to force a download from the Configurator to the FPSLIC
device. You can also power-cycle the device.
The Checksum number is the number of data bits in the bitstream file, the checksum
number shown here is for
test_fpslic.bst
file. This number can be used to check if the
data is corrupted during file transfer.
Hardware
Troubleshooting
Your design can encounter the following errors:
Error message “Expected 1 but found 0”
- No Power to the board
- Prog/ Run in the wrong position
or:
FATAL_ERROR: CMD ack_sense timed out
Double check the orientation of cable connected to evaluation board
Any other failure would be related to the following
•
Check to see that the Jumpers and Switches are in default positions, see Table 1.
•
The next area to check is the pinlocks. In Figaro, during the parts process, make
sure that you have selected to assign pinlocks. Without performing this step, your
project will not run on the board, since you have not connected the signals to the
correct pins on the board.
•
Check to see that the AVR-FPGA Interface has the correct connections.
•
Run co-verification on your design
Please refer to the CPS Troubleshooting guide for a complete description. Go to the
Help
menu and select
Contents > Trouble Shooting.
