Atmel AT91EB01, Руководство пользователя

Страница: 22 / 44

Setting Up the AT91EB01 Evaluation Board
3-10 AT91EB01 Evaluation Board User Manual
armsd -li -adp -port s=2,p -linespeed 38400
where:
-li
is the little-endian switch
-adp
is the switch to allow communication using the ARM Debug
Protocol required by Angel
-port s=2,p
indicates that the serial port is port 2 on the host computer,
and the parallel port is the standard port. The serial and
parallel ports can be shown numerically (1 or 2) or be the
host device name required
-linespeed 38400
sets the baud rate for serial communications between the
host computer and the Development System.
If you are using a version of EmbeddedICE earlier than 2.00 (that uses RDP rather than
ADP communication), enter:
armsd -li -serpar
When you enter the correct command, the host displays the debugger's opening ban-
ner, similar to:
A.R.M. Source-level Debugger vsn 4.46 (Advanced RISC Machines SDT 2.10)[Dec13
1996] EmbeddedICE Manager (ADP ARM7TDI) 2.01 (Advanced RISC Machines)
The following commands enable you to access EmbeddedICE configuration and agent
facilities from within armsd:
listconfig
lists the configurations known to the debug agent.
Note that the first configuration listed is the default
for the version of the agent in use
selectconfig
name version
specifies the target configuration to use
where:
name
indicates the configuration to use, typically
ARM7DI or ARM7TDI
version
indicates the version to be used:
any
accepts any version (default)
n
must use version n
n+
must use version n or later
The highest numbered version meeting the version constraint is used.
loadagent file
downloads the replacement agent software into
EmbeddedICE and starts it in RAM, rather than
using the one in NUM. See the “ARM Software
Development Toolkit User Guide” (ARM DUI 0040)
for further details
loadconfig file
specifies the file containing configuration data to
be loaded. Note that this option is seldom needed
because the required configuration data is usually
contained within the agent itself
For further information on using EmbeddedICE, see the “ARM Software Development
Toolkit User Guide (ARM DUI 0040)”.
3.9 Communicating
with Multi-ICE
The following is required:
■
AT91EB01 Evaluation Board
■
Multi-ICE interface unit with its 20-pin ribbon cable
■
25-pin parallel cable