20
atlona.com
Toll free: 1-877-536-3976
Local: 1-408-962-0515
Remote
3
Power
On - turns CLSO-601 on
Off - sets CLSO-601 into standby
Source Selection
HDMI1 - Input 1
HDMI2 - Input 2
HDMI3 - Input 3
HDMI4 - Input 4
VGA1 - Input 5
VGA2 - Input 6
SV1 - Input 5 (S-Video 1)
SV2 - Input 6 (S-Video 2)
CV1 - Input 5 (Composite 1)
CV2 - Input 5 (Composite 2)
COMP1 - Input 5 (Component 1)
COMP2 - Input 6 (Component 2)
Output Resolution Selection
SVGA - 800x600
XGA - 1024x768
WXGA1 - 1280x800
WXGA2 - 1360x768
SXGA - 1280x1024
SXGA+ - 1440x900
UXGA - 1600x1200
WUXGA - 1920x1200
720p
1080p
4Kx2K - 3840x2160
Native - Upscales/downscales
the output signal to match
the HDBaseT display’s
preferred
resolution
Controls
Menu - Pulls up on screen display
menu - also serves as back
button
Exit - Closes on screen display
menu
Arrows - Use to navigate the on
screen display menu and
adjust volume
OK - Enter button, use to select
choices within the on
screen display menu
Mute - Silences all audio outputs
Auto - Auto VGA setup
System IR is typically used to connect to control system processors. This input is used to control the CLSO-
601.
Note:
The IR receiver is optional for the UHD-CLSO-601. The compatible IR receiver (AT-IR-CS-RX) can be purchased
through atlona.com.
The wires of the emitter and receiver have been marked to differenciate the pin outs.
The included IR emitter has two wires: signal and ground. Signal will have a solid line and ground will be
blank. The IR emitter will plug into the IR OUT ports.
There are three wires on the IR receiver
(sold separately)
: signal, ground, and power. Signal has a dotted line,
ground will be blank, and power will have a solid line. The IR receiver will plug into the IR IN ports.
Signal (S)
Ground (
)
Signal (S)
Ground (
)
Power (P)
