AT-HDR-M2C
10
Installation
Audio Connector
Power Connector
GND
+
GND
R
L
+
The AT-HDR-M2C provides analog audio output of two-channel audio, using the included 3-pin Phoenix terminal
block.
1. Use wire strippers to remove a portion of the cable jacket.
2.
Remove at least 3/16” (5 mm) from the insulation of each wire.
3.
Insert the wires into the correct terminal on the included Phoenix block, as shown below.
4. Tighten the screws to secure the wires. Do not use high-torque devices as this may damage the screws and/or
connector block.
Locate the included orange Phoenix terminal block and wire the included power supply to the block, as shown
below. Do not use high-torque devices, when securing the wires to the Phoenix terminal block, as this may damage
the screws and/or block.
1.
Insert the wires into the correct terminal on the included Phoenix block, as shown below.
2. Tighten the screws to secure the wires. Do not use high-torque devices as this may damage the screws and/or
connector block.
Black
White
5V DC
power supply
