PAGE
15
DOC: 1310B
REV: 10-12
LC372SR SOUND REINFORCEMENT MODULE
INSTALLATION INSTRUCTIONS
EQ
Most of the adjustments made to the LC372SR are made through the LANcom SCS software. EQ adjustments are not ac-
cessible through the SCS software and must be made using the
SCS Endpoint Configurator
. First, highlight an LC372SR
and then select the
Edit
sub-menu from the
File
menu as shown in Figure 20. There are two selections for PEQ. The one
labeled
Master
is the main loudspeaker output of the device. The
Line Out
of the device can be adjusted separately.
Figure 20 -
File -> Device -> Edit Menu
Figure 21 shows the PEQ window. The main section of the window is the response curve display where you can adjust
many of the filter parameters. Additional controls are available at the bottom part of the window and a menu bar is
located at the top that is used to access various additional features.
Figure 21 -
PEQ Edit Window
Response Curve
This displays the response curve of the filter set as it is applied to the signal. You can edit many of
the individual filter parameters directly from the window using the mouse. Each filter is represented
by a red dot on the graph. You can select the filter by clicking on the dot and it will turn green. You
can then adjust the amount of cut or boost by dragging the dot up or down. You can adjust the
center frequency and bandwidth by using the arrows that appear at the top of the graph as shown
in the figure.
Selected Band
You can select the filter that you want to adjust using this row of buttons. For each output, there are
nine (9) parametric bands available along with a high-pass and low-pass filter. Some settings may
make it difficult to select the exact filter band that you want. When you select a filter band using a
button, it will be highlighted in the graph window.
