Atlas WB11, Инструкция по установке и эксплуатации

Страница: 9 / 23

REV. 03
9 / 22
4.3 WHEEL GUARD MOUNTING (ref. Fig. 6)
x
Remove the wheel guard and installation
accessories from the package.
x
Mount the guard frame onto the guard arms
fixed on the machine. Tighten the screws.
x
Mount the wheel guard onto the guard frame.
x
Check the micro switch is held down when the
guard is closed. Adjust it if necessary.
Do not clean on the guard during the wheel balancing cycle.
4.4 ELECTRIC CONNECTION
Any electric connection job must be carried out by professionally qualified
personnel.
Make sure that the power supply is right.
Make sure the connection of the phases is right. Improper electrical hook-up can
damage motor and will not be covered under warranty.
x
The machine is supplied with a single phase mains cable plus earth (ground)
x
Check to make sure the characteristics of your systems correspond to those required by the
machine.
The supply voltage (and mains frequency) is given on the machine nameplate. It
cannot be changed.
x
Connect the machine to the main electric power supply . If the machine does not include the
electric plug, the user must set one, which must conforms to the voltage of the machine, in
compliance with the regulations in force.
x
T he machine should not be started up without proper earthing.
Fig. 6
Wheel
gaurd
Gaurd
frame
Micro
switch
Gaurd arm