Atlas Copco XA(S) 186 Dd, Инструкция по эксплуатации

Страница: 19 / 44

19
Instruction Manual
3. OPERATING INSTRUCTIONS
3.1 P
ARKING
,
TOWING AND LIFTING INSTRUCTIONS
Safety precautions
.
Attention:
– Before putting the compressor in to use, check the brake system
as described in section
5.6 .
– After the first 100 km travel - Yearly or every 5000 km:
– Check and retighten the wheel nuts and towbar bolts to the
specified torque. See section 3.1.3 and section 8.1 .
– Check the brake adjustment. See section 5.6 .
3.1.1 P
ARKING INSTRUCTIONS
Fig. 3.1 Non-adjustable towbar with standard support leg without brakes
Fig. 3.2 Adjustable towbar with jockey wheel and brakes
When parking a compressor, secure support leg (1) or jockey wheel
(2) to support the compressor in a level position. Be sure that the jockey
wheel (2) is blocked by the blocking pin (6).
Apply parking brake by pulling parking brake handle (3) upwards.
Place the compressor as level as possible; however, it can be operated
temporarily in an out-of-level position not exceeding 15°. If the
compressor is parked on sloping ground, immobilize the compressor
by placing wheel chocks (available as option) in front of or behind the
wheels. Locate the rear-end of the compressor upwind, (see Fig. 3.4),
away from contaminated wind-streams and walls. Avoid recirculation
of exhaust air from the engine. This causes overheating and engine
power decrease.
Fig. 3.3 Parking position of jockey wheel
Fig. 3.4 Rear-end of compressor upwind
3.1.2 T
OWING INSTRUCTIONS
Fig. 3.5 Label on towbar, towing instructions
For both non-adjustable - and adjustable towbar, the towbar should be
as level as possible and the compressor and towing eye end in a level
position.
Push the hand brake lever (3) completely downwards and connect
breakaway cable (5) to the vehicle. Secure jockey wheel (2) or support
leg (1) in the highest possible position. The jockey wheel is prevented
from turning.
Fig. 3.6 Towing position of jockey wheel
The operator is expected to apply all relevant safety
precautions, including those mentioned on the pages
7 - 10 of this book.
(1) (5)
(4)
(7)
(3)
(4)
(5)
(2)
(6)
(4)
Before towing the compressor, ensure that the towing
equipment of the vehicle matches the towing eye or ball
connector and ensure that the service doors are closed
and locked properly.
(6)
(2)
(2)
(6)
(2)
(2)
(6)
(6)